作业帮邀请你帮忙中翻英根据你的要求,我对4个PLC端口进行一一检测,但是发现4个端口一插上数据线就跳出那个发现新硬件的提示.进行安装软件的时候图示依次如下：请问如何解决?
来源：学生作业帮助网 编辑：作业帮 时间：2024/04/29 17:26:11
邀请你帮忙中翻英根据你的要求,我对4个PLC端口进行一一检测,但是发现4个端口一插上数据线就跳出那个发现新硬件的提示.进行安装软件的时候图示依次如下：请问如何解决?
邀请你帮忙中翻英
根据你的要求,我对4个PLC端口进行一一检测,但是发现4个端口一插上数据线就跳出那个发现新硬件的提示.进行安装软件的时候图示依次如下：
请问如何解决?
邀请你帮忙中翻英根据你的要求,我对4个PLC端口进行一一检测,但是发现4个端口一插上数据线就跳出那个发现新硬件的提示.进行安装软件的时候图示依次如下：请问如何解决?
根据你的要求,我对4个PLC端口进行一一检测,但是发现4个端口一插上数据线就跳出那个发现新硬件的提示.进行安装软件的时候图示依次如下：
请问如何解决?
According to your request,I tested all the four PLC ports one by one.The prompt that there is new hardware appeared immediately when I inserted the data line into the ports.
The diagrams when I installed the software are as follows:
How can I solve such a problem?
Acquest, I have four PLC detection portal on January 1, However found four data ports onto a line that jumped out on the discovery of new hardware hints. Install the software icons were as follows : How can we solve? cording to your re
I tested all the four PLC ports according to your requriement,however,system hint pops up telling new hardware is detected as soon as I connect the data cable to the four ports.The illustration for the procedures of software installation are as following:
Could you tell me how to solve the problem?
仅供参考