英语翻译A Nd:Yag laser based laser-heating system is used in this study.The laser is microfocused to heat the sample at approximately 30 degree from the normal direction to the sample.Thermal emission is collected by a chromatically corrected obj

英语翻译A Nd:Yag laser based laser-heating system is used in this study.The laser is microfocused to heat the sample at approximately 30 degree from the normal direction to the sample.Thermal emission is collected by a chromatically corrected obj
英语翻译
A Nd:Yag laser based laser-heating system is used in this study.The laser is microfocused to heat the sample at approximately 30 degree from the normal direction to the sample.Thermal emission is collected by a chromatically corrected objective (x20) at about 15 degree from the vertical direction.A pin-hole is used to limit the field of view within 4 pm at the center of laser heated area and a single-core 200μm optical fiber is used to deliver thermal emission from the pinhole to a spectrometer coupled with a liquid nitrogen cooled CCD detector.The temperature is then determined by the fitting of thermal emission to a gray-body radiation equation.
High intensity focused monochromatic x-ray,diffracted from Si (220) at 20 KeV,is available at the beamline 10-2 of Stanford Synchrotron Radiation Laboratory (SSRL).The synchrotron x-ray
is coaxially alined at the center of laser-heating spot.The x-rays dffracted from the sample are angle-resolved by using an imaging plate.The imaging plate is typically set at the distance
approximately 200 cm apart from the sample,which can record the diffraction pattern Up to XI=45 degrees.The pathway of direct x-ray is covered with He-circulating tubes to minimize the
background exposure on the imaging plate dector.A small
adjustment of the diamond anvil cell is sometimes needed to reduce the multiple reflections arising from stong single crystal diamond diffraction lines

英语翻译A Nd:Yag laser based laser-heating system is used in this study.The laser is microfocused to heat the sample at approximately 30 degree from the normal direction to the sample.Thermal emission is collected by a chromatically corrected obj
一Nd ： YAG激光为基础的激光加热系统是用在这方面的研究.激光是microfocused热样品在约30度,从正常的方向,以样本.热辐射是收集由色更正的目标（ x20 ）在约15度,从垂直方向. 1针孔是用来限制领域的看法时至下午四时在该中心的激光加热区和一个单一的核心为200 μ m光纤是用来提供热辐射从针孔到谱仪,再加上一液氮冷却的CCD探测器.温度,然后确定装修热的废气排放,以一个灰色体辐射方程.
高强度聚焦单色X射线,衍射从在Si （ 220 ）在20千电子伏,可在光束线10月2日美国斯坦福同步辐射实验室（ ssrl ） .同步X射线
是coaxially alined在该中心的激光加热现货.该X光检查, dffracted从该样本是角分辨使用成像板.成像板通常是设在距离
大约二〇 〇厘米除了从该样本,它可以记录衍射花样最多席= 45度.途径直接X射线是与他所涵盖的循环管道,以尽量减少
背景暴露于成像板dector .一小
调整的金刚石压腔,有时是需要,以减少多次反射所产生的stong单晶金刚石衍射线