作业帮英语高手来,论文摘要翻译,汉译英.可控放大器主要包含放大器和滤波器两部分.放大器部分通过模拟开关CD4051,改变反馈电阻阻值,从而改变放大器电压增益,增益从10dB到60dB可调步距为10dB.滤波
来源：学生作业帮助网 编辑：作业帮 时间：2024/05/06 11:08:44
英语高手来,论文摘要翻译,汉译英.可控放大器主要包含放大器和滤波器两部分.放大器部分通过模拟开关CD4051,改变反馈电阻阻值,从而改变放大器电压增益,增益从10dB到60dB可调步距为10dB.滤波
英语高手来,论文摘要翻译,汉译英.
可控放大器主要包含放大器和滤波器两部分.放大器部分通过模拟开关CD4051,改变反馈电阻阻值,从而改变放大器电压增益,增益从10dB到60dB可调步距为10dB.滤波器部分采用单片机AT89S51对可编程滤波器芯片MAX262 进行程序控制,可以同时对两路输入信号进行二阶低通、高通、带通、带阻以及全通滤波处理,滤波器的中心频率在15kHz～50kHz 频率范围内实现64 级程控调节,其Q 值在0.5～64 范围实现128 级程控调节.
在线翻译的就不用回答了.
OOXX，第一个，你是在有道上翻译的。第二个，你的几乎跟谷歌翻译的一模一样。就是最后一句变了。
人心不古，世风日下啊！
摘要改了，现在是酱紫的：
本系统以单片机AT89S51最小系统为控制模块，采用高性能低噪音运算放大器NE5532和 CMOS 双二阶通用开关电容有源滤波器MAX262来完成可控放大器的设计，放大部分为了达到60dB增益可以采用两级放大，第一级先放大2倍，第二级利用模拟开关CD4051通过单片机编程来改变反馈电阻阻值，从而改变放大器电压增益，总的放大倍数为第一级与第二级放大倍数的乘积，这样就可实现电压增益从10dB到60dB可调步距为10dB，此种方法通用性强，经济实惠，效果显著，而且电路放大倍数精确、易控制、调节范围大。滤波器部分的高通、低通和带通可通过开关来切换，通过单片机对可编程滤波器芯片MAX262的中心频率f0和品质因数Q进行独立编程控制，实现对滤波器的截止频率在1kHz～20kHz范围内可调，调节的频率步进为1kHz。
英语高手们都来救救小弟吧！后天就要给指导老师看了，不然的话……会死的很残的！谢谢高手赏脸！
英语高手来,论文摘要翻译,汉译英.可控放大器主要包含放大器和滤波器两部分.放大器部分通过模拟开关CD4051,改变反馈电阻阻值,从而改变放大器电压增益,增益从10dB到60dB可调步距为10dB.滤波
可控放大器主要包含放大器和滤波器两部分.放大器部分通过模拟开关CD4051,改变反馈电阻阻值,从而改变放大器电压增益,增益从10dB到60dB可调步距为10dB.滤波器部分采用单片机AT89S51对可编程滤波器芯片MAX262 进行程序控制,可以同时对两路输入信号进行二阶低通、高通、带通、带阻以及全通滤波处理,滤波器的中心频率在15kHz～50kHz 频率范围内实现64 级程控调节,其Q 值在0.64 范围实现128 级程控调节.
The adjustable amplifier mainly includes the amplifier and the filter.Through analog switch CD4051,the amplifier alters the feedback resistance value and then alters the voltage gain at the amplifier.The adjustable steps from 10dB to 60dB at the gain are 10dB.At the filter part,a single chip microcomputer AT89S51 has been used to realize the programmed control to the programmable filter chip MAX262; it can realize second stage low pass,high pass,band pass,band resistance and all-pass filter processing simultaneously at the two inputting signals.The central frequency of the filter is between 15kHz～50kHz; a 64 level programmed adjustment is realized within that frequency range,whose Q value can be adjusted at 128 levels in the range of 0.64.
Controllable amplifier and filter amplifier consists mainly of two parts. Amplifier in part through the analog switches CD4051, change the feedback resistor, thus changing the voltage amplifier gain, ...
全部展开
Controllable amplifier and filter amplifier consists mainly of two parts. Amplifier in part through the analog switches CD4051, change the feedback resistor, thus changing the voltage amplifier gain, gain from 10dB to 60dB adjustable pace was 10dB. Filter part of the filter with the programmable microcontroller AT89S51 chip MAX262 to control, can simultaneously on the two input signals, low pass, high pass, band pass, band-stop and all-pass filter, the filter center frequency 15kHz ~ 50kHz frequency range to achieve 64 programmable adjustment, the Q value in the range of 0.5 to 64 program-controlled adjustment to achieve 128.
收起
这么专业 的 东西 怕是要花点钱 哦
Controlled amplifiers mainly contains amplifiers and filter in two parts. Through simulation CD4051 switch amplifier, change, change the feedback resistance voltage amplifier, gain 10dB to gain from 6...
全部展开
Controlled amplifiers mainly contains amplifiers and filter in two parts. Through simulation CD4051 switch amplifier, change, change the feedback resistance voltage amplifier, gain 10dB to gain from 60dB adjustable step for 10dB. AT89S51 single-chip part adopts filter for programmable filter for program control, MAX262 chip can input signal for two road, high and low let-through second-order band-pass, band-stop and full filtering processing center frequency, filter in 15kHz ~ 50kHz frequency range, the 64 class program-controlled Q value in 0.5 ~ 64 scope magnitude program-controlled adjustment. Realizing 128
收起